Metal blanking
Metal blanking
In the blanking department we have 12 eccentric presses from 40 to 200 t, 2 of which are automatic lines for coil blanking. We manufacture both "aesthetic" pieces with care to detail to satisfy the requests of architects and designers, and "mechanical" parts where tolerances and precision come into play during the manufacturing phases.
Here are some of the materials we usually process:
Here are some of the materials we usually process:
- stainless steels type 304 – 316 – 430
- Pickled and pre-galvanized iron
- Aluminium
- Brass
Cold forming
Cold forming
We have 3 screw levers with Ø 100 – Ø 170 – Ø 230, with powers ranging from 150 to 600 t. With these machines we can perform cold coining which would be impossible with other technologies.
The precision of cold forming is possible due to the absence of a lower dead center, which allows all the necessary power to be released in a fraction of a second. This makes cold coning possible without having to preheat the piece.
Our constant and in-depth research into materials and thermal treatments of coining molds allows us to produce over 100,000 parts without having to operate on the tool.
The precision of cold forming is possible due to the absence of a lower dead center, which allows all the necessary power to be released in a fraction of a second. This makes cold coning possible without having to preheat the piece.
Our constant and in-depth research into materials and thermal treatments of coining molds allows us to produce over 100,000 parts without having to operate on the tool.